hp StorageWorks fca2355 dual channel PCI host bus adapter - installation guide

5–6 fca2355 dual channel PCI host bus adapter installation guide
Diagnostic and Configuration Utilities
You can run the utility from the CD or copy and run it from your local hard drive.
NOTE: You must install and connect the SCSI Miniport driver to at least one drive before lputilnt
can operate properly. You can alternately set the registry parameter Simulate Device= to 1.
View HBA Parameters
From the LightPulse Utility/NT Main menu screen:
1. Select an HBA.
2. On the menu bar, click on an HBA or pull down the category list.
3. Select an option to view HBA parameters.
There are eight options available, each displaying a different group of HBA
parameters:
• Adapter Revision Levels—View information about the chipset and firmware
revision levels of the selected HBA.
• Loop Map—View a list of the members of the selected HBA loop map.
• PCI Registers—View the values of the PCI configuration registers for the
selected HBA.
• Configuration Data—View information about the data in each of the
configuration regions in the flash ROM of the selected HBA.
• Drive Parameters—View information about device driver parameters that are
maintained in the Windows/NT registry.
• Link Statistics—View statistics about the arbitrated loop of the selected HBA.
• Status and Counters—View status and counters for bytes, frames, sequences,
exchanges, and so on.
4. Expand the category list and select Firmware Maintenance.
5. Click Download.
6. Locate the new upgrade file.
7. Click Open.
NOTE: The new software is transferred to the HBA.
8. Expand the category list and select Adapter Revision Levels.
9. Verify that the new firmware revision is shown.