FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
CLI Commands
2-65
config
You can use the Switch Binding commands to enable Switch Binding
and to create and change the SBML. Switch Binding is available only
if the SANtegrity Binding feature is installed.
Enable, Disable and
Online State Functions
For Switch Binding to function, specific operating parameters and
optional features must be enabled. Also, there are specific
requirements for disabling these parameters and features:
• Switch Binding can be enabled or disabled whether the product is
offline or online.
• Enabling Enterprise Fabric Mode automatically enables Switch
Binding.
• You cannot disable Switch Binding if Enterprise Fabric Mode is
enabled. However, if Enterprise Fabric Mode is disabled, you can
disable Switch Binding.
• If Enterprise Fabric Mode is enabled and the director or switch is
online, you cannot disable Switch Binding.
• If Enterprise Fabric Mode is enabled and the director or switch is
offline you can disable Switch Binding, but this also disables
Enterprise Fabric Mode.
• WWNs can be added to the SBML without regard to whether
Switch Binding is enabled or disabled.
config.security.switchBinding.addMember
Syntax addMember wwn
Purpose This command adds a new member to the SBML. A maximum
number of 256 members may be added to the SBML.
Parameters This command has one parameter:
Command Example
Root> config security switchBinding addMember
AA:99:23:23:08:14:88:C1
wwn Specifies the switch or N_Port device WWN of
the member to be added to the SBML. The value
of the WWN must be in colon-delimited
hexadecimal notation (for example,
AA:00:AA:00:AA:00:AA:00).