FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
2-80
Enterprise Operating System Command Line Interface User Manual
config
Output Example The output from the config.switch.show command displays as
follows.
BB Credit: 2
R_A_TOV: 20
E_D_TOV: 4
Preferred Domain Id: 1
Switch Priority: Principal
Speed: 2 Gb/sec
Rerouting Delay: Enabled
Interop Mode: Open Fabric 1.0
Insistent Domain Id: Disabled
Domain RSCN: Enabled
Zoning RSCN: Disabled
Limited Fabric RSCN: Disabled
Zone FlexPars: Fabric
config.switch.zoneFlexPars
Syntax zoneFlexPars zoneFlexParstate
Purpose This command configures the state of Zone Flex Pars.
Zoning RSCN When enabled, allows zoning RSCNs to be sent
to registered members of the fabric.
Limited Fabric
RSCN
When enabled, fabric RSCNs are suppressed
after an IPL.
Zone Flex Pars When set to fabric, RSCNs will only be sent to
affected fabric members when zoning
information changes. When set to none, filtering
of RSCNs will not take place, and RSCNs will
be sent to all zoneset members when zoning
information changes.