FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
CLI Commands
2-81
config
Parameters This command has one parameter:
Command Example
Root> config switch zoneFlexPars fabric
config.switch.zoningRSCN
Syntax zoningRSCN zoningRSCNState
Purpose This command sets the zoning RSCN state for the switch. When
enabled, this parameter allows zoning register for state change
notifications (RSCNs) to be sent to registered members of the fabric.
Zoning RSCNs are sent to ports on the switch following any change
to the fabric’s active zone set. The switch can be either offline or
online when this command is executed.
Parameters This command has one parameter.
Command Example
Root> config switch zoningRSCN 1
config.system.contact
Syntax contact systemContact
Purpose This command sets the system contact attribute.
zoneFlexParsState This parameter can be set to fabric and
none. When set to fabric, RSCNs will only
be sent to affected fabric members when
zoning information changes. When set to
none, filtering of RSCNs will not take
place, and RSCNs will be sent to all
zoneset members when zoning
information changes
zoningRSCNState Specifies whether the zoning RSCN state is
enabled. Valid values are enable, disable, true,
and false. Boolean 1 and 0 may be substituted as
values.