FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
2-84
Enterprise Operating System Command Line Interface User Manual
config
Purpose This command shows the system configuration.
Parameters This command has no parameters.
Command Example
Root> config system show
Output The system configuration is displayed as a table that includes the
following properties.
Output Examples The output from the config.system.show command displays as
follows.
Name: Joe’s Switch
Description: McDATA Intrepid 6064 Fibre Channel Director
Contact: Joe
Location: Everywhere
Date/Time: 04/16/2001 10:34:01
config.zoning
Note that the config.zoning commands function in a different way
from most CLI commands, which are single action commands that
take effect immediately. A zoning configuration is typically too
complicated to be described by a single command, so the first zoning
command entered invokes a work-area editor. The commands take
effect on a temporary copy of a zone set in the work area until the
temporary copy in the work area is activated to the fabric--or is
discarded.
Because not all the verification of the zone set can occur on the
temporary copy in the work area, it is possible, however unlikely, that
the copy of the zone set encounters no errors until the zone set is
activated to the fabric.
Name The system name.
Description The system description.
Contact The system contact.
Location The system location.
Date/Time The system date and time.