FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
CLI Commands
2-93
config
Output The zoning configuration data is displayed as a table that includes
the following properties.
Output Example The output from the config.zoning.showActive command displays as
follows.
Active Zone Set
Default Zone Enabled: False
ZoneSet: TheUltimateZoneSet
Zone: TheUltimateZone
ZoneMember: Domain 10, Port 6
ZoneMember: Domain 15, Port 2
ZoneMember: Domain 2, Port 63
ZoneMember: 10:00:00:00:C9:22:9B:64
ZoneMember: 10:00:00:00:C9:22:9B:BD
Zone: TheNotSoUltimateZone
ZoneMember: 10:00:00:00:C9:22:9B:AB
ZoneMember: 10:00:00:00:C9:22:9B:C6
ZoneMember: 10:00:00:00:C9:22:9B:AB
Zone: TheNotUltimateAtAllZone
ZoneMember: Domain 2, Port 63
config.zoning.showPending
Syntax showPending
Purpose This command shows the zoning configuration in the work area of
the zone set that has not yet been activated.
Parameters This command has no parameters.
Command Example
Root> config zoning showPending
Output The zoning configuration data is displayed as a table that includes
the following properties.
Output Example The output from the config.zoning.showPending command displays
as follows.
Active ZoneSet The enabled status, name, and member zones of
the zone set.
Local ZoneSet The enabled status, name, and member zones of
the zone set.