FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
CLI Commands
2-115
perf
Command and
Output Examples
The following examples show the output returned by the three
methods of specifying the perf.preferredPath.showPath command.
Single values for both parameters
Root> perf preferredPath showPath 21 10
Preferred Path State: Enabled
Preferred Exit Port: Not Configured
destDomainId set to all
Root> perf preferredPath showPath all 15
Preferred Path State: Enabled
Destination Domain Preferred Exit Port
------------------ -------------------
1 23
3 24
4 23
17 12
sourcePort set to all
Root> perf preferredPath showPath 1 all
Preferred Path State: Enabled
Source Port Preferred Exit Port
------------------ -------------------
0 2
2 5
3 17
22 5
perf.preferredPath.showState
Syntax showState
Purpose This command shows the enablement state for Preferred Path
Parameters This command has no parameters.
Command Example
Root> Perf PreferredPath showState
Command Output The output from this command displays the current state of the
Preferred Path.
Preferred Path State: Disabled