FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
2-124
Enterprise Operating System Command Line Interface User Manual
perf
Parameters This command has the following parameters.
Command Example
Root> perf thresholdAlerts counter setCounter checklinks 1
perf.thresholdAlerts.counter.setParams
Syntax setParams name increment interval
Purpose This command sets the increment and interval times for a specified
counter threshold alert.
NOTE: An alert cannot be modified unless it is in the disabled state. Verify
that the alert is disabled before executing this command.
Parameters This command has the following parameters.
Example The meaning for each of these inputs can best be described using the
following example sentence:
name The name of a counter threshold alert as
defined by the command
perf.thresholdAlerts.counter.addAlert, described
on 2-120.
counterNumber Specifies the counter number. Valid values are
shown in Table 2-3, Alert Counters, page 2-118.
name The name of a counter threshold alert as
defined by the command
perf.thresholdAlerts.counter.addAlert, described
on 2-120.
increment This sets the number of times a counter must
increment during the interval period to trigger
the alert. Acceptable values are in the range of
1 to 70,560.
interval This sets the interval time in minutes for the
alert. Acceptable values are in the range of 5 to
70,560 minutes.