FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
2-132
Enterprise Operating System Command Line Interface User Manual
perf
NOTE: An alert cannot be modified unless it is in the disabled state. Verify
that the alert is disabled before executing this command.
Parameters This command has the following parameters.
Command Example
Root> perf thresholdAlerts throughput removePort eportRx all
perf.thresholdAlerts.throughput.setUtilType
Syntax setUtilType name utilizationType
Purpose This command sets the throughput statistic that is used to trigger the
throughput threshold alert.
NOTE: An alert cannot be modified unless it is in the disabled state. Verify
that the alert is disabled before executing this command.
name The name of a throughput threshold alert as
defined by the command
perf.thresholdAlerts.throughput.addAlert,
described on 2-129.
portNumber Specifies the port number. Valid values are:
0–11 for the Sphereon 4300
0–15 for the Sphereon 3016 and 3216
0–23 for the Sphereon 4500
0–31 for the Sphereon 3032 and 3232
0–63 for the Intrepid 6064
0–127 and 132–143 for the Intrepid 6140
all removes the throughput threshold alert
from every port on the product.