FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
CLI Commands
2-133
perf
Parameters This command has the following parameters.
Command Example
Root> perf thresholdAlerts throughput setUtilType
eportRx 1
perf.thresholdAlerts.throughput.setUtilPercentage
Syntax setUtilPercentage name utilizationPercentage
Purpose This command sets the throughput utilization percentage that is used
to trigger the throughput threshold alert.
NOTE: An alert cannot be modified unless it is in the disabled state. Verify
that the alert is disabled before executing this command.
Parameters This command has the following parameters.
Command Example
Root> perf thresholdAlerts throughput setUtilPercentage
eportRx 70
name The name of a throughput threshold alert as
defined by the command
perf.thresholdAlerts.throughput.addAlert,
described on 2-129.
utilizationType The type of traffic that triggers the alert. Enter
the number that corresponds to the desired
utilization type:
1 - Transmit Traffic (Tx)
2 - Receive Traffic (Rx)
3 - Both (Rx and Tx)
name The name of a throughput threshold alert
as defined by the command
perf.thresholdAlerts.throughput.addAlert,
described on 2-129.
utilizationPercentage The percentage of throughput utilization
that triggers the alert. This must be entered
as a number. Accepted values are in the
range 1 to 100.