FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
CLI Commands
2-153
show
Output The data is displayed as a table that includes the following
properties:
Output Example
Ficon MS State: Disabled
Ficon MIHPTO (seconds): 180
show.frus
Syntax frus
Purpose This command displays information about all FRUs.
Parameters This command has no parameters.
Command Example
Root> show frus
Output The FRU information is displayed as a table that includes the
following properties.
Ficon MS State The state of the Ficon MS feature.
Ficon MIHPTO The Ficon MIHPTO value in seconds.
FRU The FRU name. (This may show Unknown or
Not Installed, if the FRU is not installed.)
Position The relative position of the FRU, that is, its slot.
State The state of the FRU. Values are:
Active—the current module is active.
Backup—this module is not currently being
used, but it is available for immediate failover.
NotInst—the module is not currently installed.
Failed—the current module is failed.
Serial Num The serial number of the FRU. (This field is
blank for power supply modules of the
Sphereon 4300 and Sphereon 4500 switches.)
Part Num The part number of the FRU.
Beacon The beaconing state of the FRU (On or Off).
Pwr On Hrs The power-on hours value for the FRU.