FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
2-188
Enterprise Operating System Command Line Interface User Manual
show
Output Example The output from the show.switch command displays as follows.
State: Online
BB Credit: 2
R_A_TOV: 20
E_D_TOV: 4
Preferred Domain Id: 1
Switch Priority: Default
Speed: 2 Gb/sec
Rerouting Delay: Enabled
Interop Mode: Open Fabric 1.0
Active Domain Id: 1
World Wide Name: 10:00:08:00:88:00:21:07
Insistent Domain Id: Enabled
Domain RSCN: Enabled
Zoning RSCN: Disabled
FC Address Domain Id: 67 (hexadecimal)
Limited Fabric RSCN: Disabled
show.system
Syntax system
Purpose This command displays a set of system attributes.
Parameters This command has no parameters.
Command Example
Root> show system
Output The system attributes are displayed as a table that includes the
following properties.
Name The system name as set in the
config.system.name command. For more
information, see config.system.name on
page 2-83.
Contact The system contact as set in the
config.system.contact command. For more
information, see config.system.contact on
page 2-81.
Description The system description as set in the
config.system.description command. For more
information, see config.system.description on
page 2-82.