FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

A
Error Messages
A-21
Message Error 143: Domain RSCNs Must Be Enabled When Enterprise
Fabric Mode Active
Description The user attempted to disable domain RSCN's while enterprise fabric
mode was active.
Action Domain RSCN's must remain enabled while the enterprise fabric
mode is active. If enterprise fabric mode is set to inactive, the domain
RSCN state may be changed. It should be noted, however, that this
can be disruptive to the fabric.
Message Error 144: The SANtegrity Feature Has Not Been Installed
Description The user attempted to activate a change to the fabric security
configuration without first installing the SANtegrity feature key.
Action If this key has not been installed, contact your sales representative.
Message Error 146: Fabric Binding May Not Be Deactivated While Enterprise
Fabric Mode Active
Description The user attempted to deactivate fabric binding while enterprise
fabric mode was active.
Action Fabric binding must be active while operating in enterprise fabric
mode. The fabric binding state may be changed if enterprise fabric
mode is deactivated. It should be noted, however, that this can be
disruptive to the fabric.
Message Error 147: Cannot Complete Request While SW Trunking Is
Enabled
Description Cannot perform this action because the SW Trunking feature is
enabled.
Action Disable the SW Trunking feature.