FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
2-10
Enterprise Operating System Command Line Interface User Manual
config
Output Example The output from the config.features.show command displays as
follows.
Installed Feature Set Feature State
------------------------------ ------------------ -----
Flex Ports 8 Flex Ports Enabled
SANtegrity Fabric Binding Active
SANtegrity Switch Binding Enabled
SANtegrity Enterprise Fabrics Active
Open Trunking Open Trunking Enabled
NOTE: The command show.features on page 2-150.has functionality that is
identical to this command.
config.fencing.addPolicy
Syntax addPolicy name
Purpose This command configures a new fencing policy and assigns it a name.
The new policy is assigned default settings, which must be changed
before the policy is activated.
See config.fencing.setParams on page 2-12 for default settings.
Parameters This command has one parameter.
Command Example
Root> config fencing addPolicy Policy2
NOTE: The maximum number of policies supported is 14.
config.fencing.addPort
Syntax addPort name portNumber
Purpose This command adds a port to the specified fencing policy.
name Specifies the name of the new fencing
policy. This name can consist of any
printable USASCII characters up to a
maximum length of 63 characters. This
name is case-sensitive.