FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
2-26
Enterprise Operating System Command Line Interface User Manual
config
Parameters This command has two required parameters.
Command Example
Root> config port fan 4 1
config.port.name
Syntax name portNumber portName
Purpose This command sets the name for a port.
Parameters This command has two required parameters.
Command Example
Root> config port name 4 Sam’s tape drive
config.port.rxCredits
Syntax rxCredits portNumber numRxCredits
Purpose This command is used to set the number of initial BB Credits for a
given port. The number of credits assigned must fall between the
minimum and maximum allowed values for the port.
portNumber Specifies the port number. Valid values are:
0–23 for the Sphereon 4500
fanOn Specifies the FAN state for the port. Valid values
are true and false. Boolean 1 and 0 may be
substituted as values.
portNumber Specifies the port number. Valid values are:
0–11 for the Sphereon 4300
0–15 for the Sphereon 3016
0–23 for the Sphereon 4500
0–31 for the Sphereon 3032
0–63 for the Intrepid 6064
0–127 and 132–143 for the Intrepid 6140
portName Specifies the name for the port. The port name
must not exceed 24 characters in length.