FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
CLI Commands
2-27
config
Parameters This command has two required parameters:
Command Example
Root> config port rxCredits 8 40
config.port.show
Syntax show portNumber
Purpose This command displays the current configuration for the specified
port.
Parameters This command has one parameter.
portNumber Specifies the port number. Valid values
are:
0–11 for the Sphereon 4300
0–15 for the Sphereon 3016
0–23 for the Sphereon 4500
0–31 for the Sphereon 3032
0–63 for the Intrepid 6064
0–127 and 132–143 for the Intrepid 6140
numBBCredits Specifies the number of Rx BB Credits to
assign the specified port.
For the Sphereon 4300 and Sphereon 4500
the RxCredits per port must be between 2
and 12. The total number of Rx Credits
assigned across all ports must not exceed
the maximum pool size of 150.
For the Intrepid family, the RxCredits per
FPM/UPM port must be between 1 and
60. The RxCredits per XPM port must be
between 4 and 400. There is no pool
limitation.
portNumber Specifies the port number. Valid values are:
0–11 for the Sphereon 4300
0–15 for the Sphereon 3016
0–23 for the Sphereon 4500
0–31 for the Sphereon 3032
0–63 for the Intrepid 6064
0–127 and 132–143 for the Intrepid 6140