FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
CLI Commands
2-31
config
Purpose This command will swap two ports given the port numbers. The
ports must be offline to perform this operation.
Parameters This command has two required parameters:
Command Example
Root> config port swapPortByAddr 1e 1f
config.port.type
Syntax type portNumber portType
Purpose This command sets the allowed type for a port.
A port can be configured as an F_Port, an E_Port, or a G_Port. On a
Sphereon 4300 or Sphereon 4500, a port can also be an Fx_port or
Gx_port.
NOTE: On the Sphereon 4300 Switch, the E_Port, G_Port, and GX_Port
options are not valid, unless the Fabric Capable feature is enabled. For more
information, see the McDATA Sphereon 4300 Switch Installation and Service
Manual (620-000171).
The port configurations function as follows:
• F_Port—cannot be used as an interswitch link, but may attach to a
device with an N_Port.
• E_Port—only other switches may attach to this type of port.
• G_Port—either a device or another switch may attach to this type
of port.
• Fx_Port — allows Arbitrated Loop operation in addition to the
functionality of an F_Port. (Sphereon 4300 and Sphereon 4500
only.)
• Gx_Port—allows Arbitrated Loop operation in addition to the
functionality of an F_Port or an E_Port. (Sphereon 4300 and
Sphereon 4500 only.)
portNum1 Port number, in hexidecimal format, of
the desired port to be swapped
portNum2 Port number, in hexidecimal format, of
the desired port to be swapped