FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
2-40
Enterprise Operating System Command Line Interface User Manual
config
Parameters This command has one required parameter, and one optional
parameter:
NOTE: A preferred method of local and a backup method of RADIUS is not
an accepted combination because the local method can always be contacted.
Command Example Root> config security authentication interface cli
sequence RADIUS local
config.security.authentication.port.override
Syntax override portNumber [overrideState]
Purpose This command sets the outgoing override state for a single port. This
setting allows you to override the default outgoing authentication
state for either the E_port or N_port interface. The default setting will
cause the port to use the outgoing state configure for the
corresponding interface (either E_port or N_port).
NOTE: This command requires that the SANtegrity Authentication feature
key be installed.
method1 This sets the preferred method of
authentication for the CLI interface.
Accepted values are local or RADIUS.
method2 This optional parameter sets the backup
method of authentication for the CLI
interface. This backup method is used
when the preferred method cannot be
contacted. Accepted value is local.