FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
2-54
Enterprise Operating System Command Line Interface User Manual
config
config.security.fabricBinding.addMember
Syntax addMember wwn domainId
Purpose This command adds a new member to the Pending FBML in the
fabric binding work area. The number of entries is limited to the
maximum available domain IDs for the fabric, which is 239.
NOTE: Changes from this command are not activated to the fabric until the
activatePending command is issued.
Parameters This command has two parameters:
Command Example
Root> config security fabricBinding addMember
AA:99:23:23:08:14:88:C1 2
config.security.fabricBinding.clearMemList
Syntax clearMemList
Purpose This command clears the Pending FBML in the working area.
Members that are attached remain in the list, because the Pending
FBML must contain all attached members to become active.
NOTE: This information is not saved to the fabric until the activatePending
command is issued. When the list is cleared, the CLI automatically adds the
managed switch to the Pending FBML.
Parameters This command has no parameters.
Command Example
Root> config security fabricBinding clearMemList
wwn Specifies the world wide name (WWN) of the
member to be added to the Pending FBML. The
value of the WWN must be in colon-delimited
hexadecimal notation (for example,
AA:00:AA:00:AA:00:AA:00).
domainId The domain ID of the member to be added to
the Pending FBML. Valid domain IDs range
from 1 to 239.