HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software Command Line Interface Reference Guide (EK-G80CL-RA. C01, March 2005)

CLI Command Descriptions
124 HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software
Command Line Interface Reference Guide
Deletes a specified container belonging to the controller configuration.
Note: A container cannot be deleted if the container is in use by a higher-level
container. For example, a disk belonging to a member of a RAIDset, or a RAIDset unit,
cannot be deleted. To delete a member of one of these storagesets, the higher-level
container or containers must be deleted first.
Also, to delete a unit that belongs to a remote copy set, the remote copy set must be
deleted first. (There is one exception to this rule: a remote (target) member of a remote
copy set can be deleted from the copy set.)
Note: This command does not delete failedsets or sparesets (see DELETE
FAILEDSETS on page 126 and DELETE SPARESETS on page 129 for details).
After a storageset is deleted, the individual disks are free to be used by another
container. If you create the container again with the exact same disk
configuration, and none of the disks are used for anything or initialized, the
container can be reassembled using its original disks.
Syntax
DELETE container-name
Parameters
The following parameter supports the DELETE command:
container-name
Identifies the container to be deleted. This is the name given to the container
at the time it was created using the ADD command (for example, ADD
DISKS, ADD STRIPESETS, and so forth).
Switches
There are no switches associated with this command.
DELETE container-name