HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software Command Line Interface Reference Guide (EK-G80CL-RA. C01, March 2005)

CLI Command Descriptions
173HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software
Command Line Interface Reference Guide
Flushes the data from the specified controller writeback cache (if present) and
shuts down the controller. It then restarts the controller in looping Self-test mode.
Press the controller Reset button to take the controller out of Self-test mode.
Syntax
SELFTEST controller
Parameters
The following parameter supports the SELFTEST command:
controller
Identifies which controller is to perform the SELFTEST controller
command. You must specify THIS_CONTROLLER (the one connected to the
CLI maintenance terminal) or OTHER_CONTROLLER.
Switches
The following switches support the SELFTEST controller command:
■ IGNORE_ERRORS and NOIGNORE_ERRORS
■ IMMEDIATE_SHUTDOWN and NOIMMEDIATE_SHUTDOWN
These switches are described in the following paragraphs.
IGNORE_ERRORS
NOIGNORE_ERRORS
(default)
Instructs the controller how to respond to writeback cache errors.
Caution: The IGNORE_ERRORS switch can cause data to remain in
writeback cache. Do not perform any hardware changes until the controller
flushes the cache.
SELFTEST