HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software Command Line Interface Reference Guide (EK-G80CL-RA. C01, March 2005)

CLI Command Descriptions
187HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software
Command Line Interface Reference Guide
This switch works in SCSI-2 mode only. This switch has no effect in SCSI-3
mode. SCSI mode is set by the SCSI_MODE switch of this command.
■ Select COMMAND_CONSOLE_LUN to enable the CCL.
■ Select NOCOMMAND_CONSOLE_LUN to disable the CCL.
If all LUNs have already been allocated and you attempt to enable the CLL,
the following message displays:
Error 1230: Command console LUN can’t be enabled
because all LUNs are allocated.
CONNECTIONS_LOCKED
CONNECTIONS_UNLOCKED (default)
Controls access to the connection table maintained in NonVolatile RAM
(NVRAM). If the table is locked, the host login request (PLOGI) is rejected
(unless the connection is already in the table) and the request is stored
internally in a rejected hosts table. If a login request is received while the
connection table is unlocked, the connection is granted if there is room in the
connection table.
■ Enter CLI> SET <THIS | OTHER> CONNECTIONS_LOCKED to
lock the table.
■ Enter CLI> SET <THIS | OTHER> CONNECTIONS_UNLOCKED
to unlock the table.
Note: The CONNECTIONS_LOCKED and CONNECTIONS_UNLOCKED switches must
be typed completely to prevent inadvertently changing the state of the lock.
Note: The ADD CONNECTIONS command is not affected by the state of the lock.
DEFAULT_ACCESS=ENABLE (default)
DEFAULT_ACCESS=DISABLE
Specifies whether newly added units automatically allow connections
between host computers and the controller.