HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software Command Line Interface Reference Guide (EK-G80CL-RA. C01, March 2005)

CLI Command Descriptions
227HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software
Command Line Interface Reference Guide
Changes the characteristics of the specified RAIDset.
Note: The number and type of disk drives that are used to create the storageset
determine the maximum size of the RAIDset.
Syntax
SET RAIDset-name
Parameters
The following parameter is associated with the SET command:
RAIDset-name
Specifies the name of the RAIDset to modify. This is the name used with the
ADD UNITS command to identify the RAIDset as a host-addressable unit.
Switches
The following switches support the SET RAIDset-name command:
■ POLICY and NOPOLICY
■ RECONSTRUCT
■ REMOVE
■ REPLACE
These switches are described in the following paragraphs.
POLICY=BEST_FIT
POLICY=BEST_PERFORMANCE (default)
NOPOLICY
Specifies the replacement policy to use if a member within the RAIDset fails.
SET RAIDset-name