HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software Command Line Interface Reference Guide (EK-G80CL-RA. C01, March 2005)

CLI Command Introduction
47HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software
Command Line Interface Reference Guide
Command syntax
Each CLI command is described using the following structure:
COMMAND <PARAMETER_NAME=parameter> SWITCHES
■ COMMAND—A word or phrase expressed as a verb used to instruct the
controller what to do. Commands are represented in this guide in capitalized
form.
■ PARAMETER_NAME—The name of a parameter, followed by an equal sign
and the parameter variable. If a specific command specifies parameter names,
they must be entered in the command string. Parameter names are represented
in this guide in capitalized form.
Table 3: Recall and Edit Command Keys
Keystroke Description
Up Arrow or Ctrl+B,
Down Arrow or Ctrl+N
Steps forward or backward through the four most
recent CLI commands.
Left Arrow or Ctrl+D,
Right Arrow or Ctrl+F
Moves the cursor left or right in a command line.
Ctrl+E Moves the cursor to the end of the line.
Ctrl+H Moves the cursor to the beginning of the line.
Ctrl+J or Linefeed key Deletes the word to the left of the cursor.
Ctrl+U Deletes all characters on the same line as the cursor.
Ctrl+A or F14 Toggles between Insert and Overstrike mode:
■ The default setting is Insert mode allowing you to
insert characters at the cursor location (moving
the existing characters to the right).
■ Overstrike mode replaces existing characters. The
CLI prompt returns to Insert mode at the beginning
of each line.
Ctrl+R Recalls the contents of the command line. This function
is especially helpful if the system issues a message that
interrupts your typing.