HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software Command Line Interface Reference Guide (EK-G80CL-RA. C01, March 2005)

CLI Command Descriptions
70 HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software
Command Line Interface Reference Guide
Names a passthrough device and adds it to the controller configuration. This
command is typically used if passthrough devices are added to a previously
configured subsystem. During initial setup, the entire device set is customarily
added to the controller configuration through the CONFIG utility.
Note: HP StorageWorks EMA series cabinets support a maximum of 84 physical
storage devices, even though more than 84 target IDs are available. HP StorageWorks
BA370 and RA8000 series enclosures and cabinets support a maximum of 72
physical storage devices. Do not exceed the maximum number of physical devices in
the subsystem.
Syntax
ADD PASSTHROUGH passthrough-name scsi-port-target-lun
Parameters
The following parameters are required for the ADD PASSTHROUGH command:
■ passthrough-name
■ scsi-port-target-lun
These parameters are described in the following paragraphs.
passthrough-name
Assigns a name to the passthrough device. This container name is then used
with the ADD UNITS command to create a logical unit.
The passthrough name can consist of a maximum of nine printable characters
excluding commas and backslashes.
A passthrough device is commonly named PASSpttll, where pttll is the
disk port-target-LUN address. Although other naming conventions are
acceptable, this naming convention presents the type of passthrough device
and the passthrough device SCSI location.
ADD PASSTHROUGH