HP StorageWorks HSG80 ACS Solution Software V8.8 for IBM AIX Installation and Configuration Guide (AA-RV1HA-TE, March 2005)

Installing, Configuring, and Removing the Client
219HSG80 ACS Solution Software V8.8 for IBM AIX Installation and Configuration Guide
Installing the Integration Patch
The integration patch determines which version of firmware the controller is using
and launches the appropriate StorageWorks Command Console (SWCC) Storage
Window within Insight Manager (CIM) V4.23.
Should I Install the Integration Patch?
Install this patch if your HSG80 controller uses ACS 8.6 or later. This patch
enables you to use the controller’s SWCC Storage Window within CIM to
monitor and manage the controller.
Installing the Integration Patch
Perform the following steps to install the integration patch.
1. Verify that you have installed the HSG80 Storage Window for ACS 8.6 or
later in the Add/Remove Programs in the Windows Control Panel. The
HSG80 Storage Window for ACS 8.6 or later is needed to open the correct
Storage Window for your version of the firmware.
2. Verify that you have installed HSG80 Storage Window V2.1 in the
Add/Remove Programs (HP StorageWorks HSG80 V2.1) in the Windows
Control Panel. The HSG80 Storage Window V2.1 is required to run the
integration patch.
3. Verify that you have installed CIM V4.23.
Install the integration patch by double-clicking on
SWCC\Client\HSG80shim\setup.exe in the AIX kit directory.The patch is
installed in the same location as the original SWCC installation.
Caution: Do not remove the HSG80 Client from your computer. If you
remove the HSG80 Client, you no longer are able to access its Storage
Window.
Caution: If you remove the integration patch, HSG80 Storage Window V2.1
no longer works and you need to reinstall HSG80 Storage Window V2.1.
The integration patch uses some of the same files as the HSG80 Storage
Window V2.1.