HP StorageWorks HSG80 ACS Solution Software V8.8 for IBM AIX Installation and Configuration Guide (AA-RV1HA-TE, March 2005)

229HSG80 ACS Solution Software V8.8 for IBM AIX Installation and Configuration Guide
C
HACMP Notes for AIX
Supported Versions of HACMP
HACMP is the acronym for High Availability Cluster Multi-Processing.
Only HACMP/ES 4.4.1.x and 4.5 are supported with the solution software.
Installing Solution Software for AIX V8.8 on HACMP Cluster
The installation procedures are the same as those for a standalone node. The
solution software must be loaded on each server in the cluster as if it were a
standalone node.
Uninstalling Solution Software for AIX on HACMP Cluster
The uninstall procedure is the same as for a standalone node. It is important to
note that you should remove any volume groups that are associated with any
HSG80 RAID Array before you execute either
cpq_hsg_uninstall or the
UNINSTALL utility on the solution software CD-ROM. The solution software
must be uninstalled on each node in the cluster.
Adding a Virtual Disk After IPL to HACMP Cluster
The procedure for adding a volume group in an HACMP cluster is different than
adding one on a stand-alone server. The difference here is that you must create a
shared volume group between the two servers that can be managed by HACMP.
The following is a procedure to create a shared volume group on two servers in a
cluster.
Creating a Volume Group on a Virtual Disk
This procedure was done on a two node cluster, brutus and miranda, running
HACMP/ES 4.4.1. This procedure does not supersede the procedure outlined in
the HACMP documentation on creating a shared volume group. These steps are