HP StorageWorks HSG80 ACS Solution Software V8.8 for Windows NT, Windows 2000, and Windows Server 2003 (32-bit) Installation and Configuration Guide (AA-RV1XA-TE, March 2005)

Preparing the Host System
125HSG80 ACS Solution Software V8.8 for Windows NT, Windows 2000, and Windows Server
2003 (32-bit) Installation and Configuration Guide
Note: Solely for the purpose of performing upgrades to the ACS firmware, this Solution
Software Kit supports previous ACS V8.6 and V8.7. Do not mix ACS versions in the
same SAN.
Refer to the HP StorageWorks HSG60 and HSG80 Array Controller and Array
Controller Software Maintenance and Service Guide and the Solution Software
Release Notes for the latest information on upgrades.
Note: If updating ACS firmware, complete the upgrade after all Windows server
upgrades. Be sure to back up data before updating servers.
Note: Disconnect fiber cables before proceeding.
These procedures are only applicable to Secure Path Version 3.x products and
upgrades, and require Secure Path Version 3.1A Service Pack 2 or Secure Path
4.0.
To obtain Service Pack 2 for Secure Path Version 3.1A, visit the web site:
http://www.compaq.com/products/sanworks/secure-path/index.html
New Installations
Note: FCA should not be connected at this time.
Note: For Silent Installation, see “Solution Software Silent Installation” on page 132.
1. Using your Solution Software CD-ROM, click the Solution Software v8.8
for Windows NT/2000/Server 2003 link.
a. Click the Perform Multi Driver Install/Update link to install the HBA
driver.