HP StorageWorks 1000/1500 Modular Smart Array firmware updating guide (370881-002, June 2007)

3. Browse the contents of the CD to locate and read the readme.txt file, which includes notes and
information about the CD.
4. To update the HBA driver:
IMPORTANT:
Secure Pa th environments must uni nstall Secure Path prior to updating HBA drivers and
must reinstall Secure Path after the new HBA drivers are installed.
NOTE:
To build an HBA driver from source code or manually patch the Linux kernel, refer to the
Readme.txt file in the /opt/hp/src/hp_qla2x00src dire ctory on the Linux server.
a. Navigate to th
e /RDP/Linux/ directory on the CD.
b. List the cont
ents of the directory and navigate to either the Emulex or QLogic directory,
depending on
the maker of your HBA.
c. Change to the CD directory for your operating system version and list the contents of the
directory.
d. Enter the fo
llowing command to install the new HBA driver:
./INSTALL —f
5. To update the ACU:
a. Uninstall
any previous version of ACU.
b. From the c onsole, navigate to the /ACU/Linux/x86 directory on the CD.
c. List the contents of the directory and identify the ACU installation rpm fileforyourenvironment.
d. Enter the
following command to install/update the ACU:
rpm -Uvh <rpm filename>
(Where <rpm filename> is the name of the ACU installation rpm file.)
NOTE:
Warning messages regarding driver version dependencies may be displayed. These
messages do not affect the MSA and may safely be ignored.
e. Start the ACU and verify your settings.
6. Remove the Suppor t Software CD from the CD-ROM drive, and then restart the server.
7. Repeat the steps in this section on each server with access to the MSA.
8. If necessary, reconnect the MSA to the SAN.
Using the Support Software CD (NetWare)
1. With the HBAs installed in the server, apply power, start your NetWare operating system, a nd log on
as a user with administrative rights.
2. Insert the MSA Support Soft ware CD into the CD -ROM drive of the server, and then mount the
CD-ROM.
3. Browse the contents of the CD to locate and read the readme.txt file, which includes notes and
information about the CD.
4. To update the HBA driver:
a. Enter the following command:
1000/1500 Modular Smart Array firmware updating guide
19