HP StorageWorks 1000/1500 Modular Smart Array firmware updating guide (370881-002, June 2007)

HPSSCDxxx :\netware\hpsetup.nlm

(Where HPSSCDxxx is the label of the MSA Support Software CD.)

After a few moments, the driver installation screen is displayed.

b. Follow the onscreen instructions to complete the driver installation.

c. After the driver is installed, load the NetWare Conﬁguration Utility by entering:

NWCONFIG

d. In the Conﬁguration O ptions window, select NCF ﬁles Options, and then press Enter.

e. Select the Edit STARTUP.NCF ﬁle, and then press Enter.

f. At Specify a server boot path:, enter the path.

The default path is: C:\NWSERVER

g. Enter the following LOAD comma nd for each HBA, using the appropriate slot number to indicate

where the HBAs are inserted in the ser ver:

LOAD QL2300.HAM SLOT = <XX> /LUNS /ALLPATHS /PORTNAMES

(Where <xx> represents the slot number.)

h. Press F10 to save the changes, and then return through all previous menus.

5. Remove the MSA Support Software C D from the CD-ROM drive, and then restart your NetWare

server.

6. Repeat the steps in this section on each NetWare server with access to the MSA.

Using the Su

pport Software CD (HP-UX)

1. With the H BAs installed in the server, power on the ser ver, start your HP-UX operating system,

and log on a

s a user with administrative rights.

2. Insert th

e MSA Support Software CD into the CD-ROM drive of the server, and then mou nt the

CD-ROM.

3. Browse the contents of the CD to locate and read the readme.txt ﬁle, which includes notes and

informat

ion about the CD.

4. To update the Array Conﬁguration Utilit y-Command Line Interface (ACU-CLI):

a. Navigate to the / H PUXACUCLI/HP-UX directory for your environment.

b. List the contents of the directory and identif y the ACU-CLI depot ﬁleforyourenvironment.

c. Copy th

eACU-CLIdepotﬁle and its corresponding readme ﬁle to a temporary directory on

the ser ver. For example:

# cp /cdrom/HPUXACUCLI/HP-UX/IA64/HPACUCLI_IA_v7.47–1.depot .tmp

d. Instal

l the ACU-CLI application using the swinstall command. For example:

# swinstall —s /tmp/HPACUCLI_IA_v7.47–1.depot

e. Remove the MSA Support Software CD from the CD-ROM drive, and then restart your HP-UX

server

f. Repeat the steps in this section on ea ch HP-UX server with access to the MSA.

Updating the components