HP StorageWorks 1000/1500 Modular Smart Array firmware updating guide (370881-002, June 2007)

• Flash All Attached Fan Control Modules: Update the fan module ﬁrmware on the MSA fans,

including fans in any MSA20 storage enclosures attached to the selected MSA.

NOTE:

If an updating option is not supported for the bundled ﬁrmware or hardware conﬁguration,

the option is shaded and cannot be selected.

7. Read the warning window, and then click Continue.

The updating process automatically begins, updating the speciﬁed components.

NOTE:

TheMSAcontrollerdisplaysthemessageFIRMWARE FLASH STARTED when it starts the

download, and FIRMWARE FLASH DONE when the download is complete.

8. Wait for the Flash Successful pop-up message to b e displayed.

9. Click Exit.

10. Power-cycle the updated MSA and any attached storage enclosures in the following sequence:

NOTE:

TheMSAstoragesystemmustberestartedtoactivatenewﬁrmware.

a. Press and hold down the MSA Power on/Standby button for approximately ﬁve seconds to

place the MSA in Standby mode.

b. Power off all storage enclosures attached to the MSA.

c. Wait approximately two m inutes to ensure that the hard disk drives in the enclosures stop

rotating.

d. Restart all storage enclosures attached to the MSA.

e. Wait approximately four minutes to allow the enclosur es to complete their startup routines.

f. Press and release the MSA Power on/Standby button to restart the MSA.

g. Wait (up to eight minutes) for the STARTUP COMPLETE message to display on the MSA

controller LCD panel.

Updating the components