HP StorageWorks 1000/1500 Modular Smart Array firmware updating guide (370881-002, June 2007)
7. Enter the following command to open the MSA_UTIL firmware flash program:
RUN SYS$ETC:MSA_UTIL
8. Enter the show controller c om m and to see a list of MSA controllers on the SAN:
Example command and response:
MSA> SHOW CONTROLLER/BRIEF
A default controller is not set. All matching controllers displayed:
Controller: $1$GGA400:
MSA1xxx (C) COMPAQ P56350B9IMX025 Software 3.36
NODE_ID = 500805f3-0001b290
Controller Identifier: 400
Current Redundancy mode: Active/Standby
Current Role: Active
Controller: $1$GGA401:
Controller Identifier: 401
MSA1xxx (C) COMPAQ P56350B9IN20HW Software 3.36
NODE_ID = 500805f3-0001b290
Current Redundancy mode: Active/Standby
Current Role: Standby
9. Enter the set controller command to indicate the controller to be flashed:
Example command and response, using th e sample information in Step 8:
MSA> SET CONTROLLER $1$GGA400.
10. Enter the flash firmware command to begin the update:
Example command and response, using th e sample information in Step 1:
MSA> FLASH FIRMWARE MSAV686B272.BIN
Sending Flash Command. Please wait.
New firmware will be loaded when THIS_CONTROLLER is reset.
NOTE:
The MSA displays the message FIRMWARE FLASH STARTED when it starts the download
and FIRMWARE FLASH DONE when the download is complete.
11 . After the controller displays FIRMWARE FLASH DONE, do one of the following:
• If you have one MSA with a single controller, the firmware update procedure is complete.
Proceed to Step 12.
• If you have one MSA with dual controllers, you must update the firmware on the second
controller. Repeat Step 8 through Step 10to update the firmware on that controller .
• If you have multiple MSAs, repea t Step 8 through Step 10 foreachcontrollerineachMSA.
12. Enter the following comma nd to exit the update utility:
MSA> EXIT
13. After all MSA controllers have been updated and the controller displays FIRMWARE FLASH DONE,
power-cycle the MSA by doing the following:
a. Remove power from the MSA.
b. After a few moments, r eapply po wer to the MSA.
After the MSA completes its start up routine, the STARTUP COMPLETE message is display ed:
14. To verify that the firmware was updated, use the following commands:
$ RUN SYS$$ETC:MSA_UTIL
MSA> SHOW CONTROLLER/BRIEF
A default controller is not set. All matching controllers displayed:
30
Updating the components