HP StorageWorks MSA1500 cs SCSI I/O Module Replacement Instructions (April 2004)

Step 1: Removing the module

Note: Before removing the SCSI I/O module, label all cables. This

ensures their reconnection in the correct configuration.

1. Disconnect all SCSI cables from the SCSI I/O module.

2. Lift the port-colored SCSI I/O module latch 1 and pull the

SCSI I/O module out of the enclosure 2.

Figure 2: Removing the SCSI I/O module

Step 2: Installing the module

To install a SCSI I/O module:

1. Slide the SCSI I/O module into the bay until it clicks into

place.

Figure 3: Installing the SCSI I/O module

2. Reconnect all SCSI cables.

Note: Make sure that all of the SCSI connectors are fastened tightly.

Verifying the replacement

After replacing the failed SCSI I/O module, verify that:

■ No error messages are displayed on the controller LCD.

■ The status LED is solid green.Returning the failed

component.

Returning the failed component

Please follow the return instructions provided in the

replacement component package.

Additional information

For additional information, refer to the MSA technical

documents web site at

http://www.hp.com/go/msa1500cs