HP StorageWorks 1510i Modular Smart Array installation and user guide (383070-002, July 2008)
Message Type
Description Action
02 ENABLE VOLUME
<n>? ‘<'=NO,
‘>'=YES
User input
An issue has been found with a
configured volume that may result
in data loss, so the volume has
been disabled. The exact nature of
theissueisdetailedinaprevious
LCD display message.
Yes = the volume is enabled
(regardless of the issue). The
volume attempts to return to its
normal operating state and the
data is accessible.
No (or no input) = the volume
remains disabled. The volume
stays in the failed state and the
data is not accessible. During this
time, the user can attempt to fix
the issue.
03 CRITICAL
LOCK-UP DETECTED.
CODE=<n>h
Error
A critical error has been detected
by the array controller firmware.
To prevent any possible data loss,
the firmware has entered a lock-up
state. The provided code contains
engineering specificinformation
about the lock-up condition.
In dual-controller configurations
where only one controller is
locked-up, remove the array
controller in question, wait 10
seconds, and then reinsert it,
ensuring that it is fully seated in
the chassis.
In single-controller configurations
and in dual-controller
configurations where both
controllers are locked-up, restart
the MSA chassis.
If the issue persists, contact HP
support.
04 ENABLE VOLUMES
? ‘<'=NO, ‘>'=YES
User input
An issue has been found with all
of the configured volumes that
may result in data loss. The exact
nature of the issue is detailed in a
previous display message.
Yes = the volume is enabled
(regardless of the issue). The
volume attempts to return to its
normal operating state and the
data is accessible.
No (or no input) =thevolume
remains disabled. The volume
stays in the failed state and the
data is not be accessible. During
this time, the user can attempt to
fixtheissue.
05 SYSTEM NAME:
<name>
Informational
The user-assigned name for the
MSA system. This name can
be assigned using the Storage
Management Utility (SCU) or the
MSA Command Line Interface
(MSA-CLI).
06
RESTARTING
S
YSTEM
Informational
The system is being restarted.
108
MSA controller LCD panel message descriptions