HP StorageWorks 1510i Modular Smart Array installation and user guide (383070-002, July 2008)

Message Type
Description Action
108 VOLUME #<n>
STATE MISSING
DRIVES
Error
The configured volume is missing
too many of the SCSI hard drives
that it is composed of, making it
unusable. The volume is disabled.
Power off the MSA and then
all attached storage enclosures.
Unplug and reinsert all SCSI hard
drives ensuring they are fully
seated in their bays. Check the
cables connecting the MSA to
any attached storage enclosures.
Power on the attached enclosures
and then the MSA.
109 VOLUME #<n>
STATE WRONG DRIVE
REPLACED
Error
The configure
dvolumeappears
to have had k
nown, good SCSI
drives replaced instead of known,
failed drives.
PowerofftheMSA.Restorethe
good drives and replace the failed
drives.
110 VOLUME #<n>
EXPANSION DISABLED
Informational
The volume expansion operation
on the configured volume has been
disabled. This may be because
a rebuild operation is ongoing,
another expansion is already
running, or the cache memory is
disabled due to a low battery.
The expansion will start after the
condition has been cleared.
111 VOLUME #<n>
INITIALIZING
PARITY
Informational
The array controller is calculating
and storing parity information
for the configured volume and
therefore performance may be
lower until it completes.
112 VOLUME #<n>
REBUILD FAILURE
Error
The r
ebuildoperationonthe
con
figured volume has failed.
If the
volume is still operating in
rege
nerative mode, remove the
new S
CSI drive that was added
as a r
eplacement for the original
failed drive and replace it with a
different new drive.
113 VOLUME #<n>
EXPANSION FAILURE
Error
The volume expansion operation
on the configured volume has
failed.
Open the HP Storage Management
Utility or MSA-CLI and use it to
determine the state of the volume.
Ifthevolumeisstilloperational,
then it is possible to retry the
operation.
114 VOLUME #<n>
STATE DELETED
Informational
The configured volume has been
deleted and is no longer available.
Volumes are deleted by using the
HP Storage Management Utility or
MSA-CLI.
115 VOLUME #<n>
MEDIA EXCHANGED
Informational
All failed hard drives of the
specified volume have been
replaced by good hard drives
orallunpluggedharddrivesin
thevolumehavebeenplugged
back in. This message should be
followed by message 02 ENABLE
VOLUME <n>? '<'=NO,
'>'=YES.
See the entry for 02 ENABLE
VOLUME <n>? '<'=NO,
'>'=YES.
120 CONFIGURED
VOLUMES <n>
Informational
The specified number of configured
volumes were detected at power
up.
1510i Modular Smart Array installation and user guide
119