HP StorageWorks 1510i Modular Smart Array installation and user guide (383070-002, July 2008)

Message Type
Description Action
121 NO VOLUMES
DETECTED
Informational
No configured volumes were
detected at power-up.
If there are supposed to be
configured volumes, power off the
MSA and then all attached storage
enclosures. Unplug and reinsert all
SCSI hard drives ensuring they are
fully seated in their bays. Check
the cables connecting the MSA to
any attached storage enclosures.
Power on the attached enclosures
and then the MSA.
122 NEW VOLUME(S)
DETECTED
Informatio
nal
Configured v
olumes from another
array contr
oller were migrated
to this arra
y controller. The
configurat
ion information has been
updated.
123 TOO MANY
VOLUMES DETECTED
Error
The array controller supports
amaximumof32configured
volumes. More than 32 volumes
were detected at power up. This
typically occurs when migrating
asetofvolumesfromone
array controller to a different
array controller that already has
configured volumes on it. The
migrated volumes have not been
added.
Remove the migrated volumes and
run the HP Storage Management
Utility or MSA-CLI. Delete any
unneeded volumes until the
number of existing volumes plus
the number of migrated volumes is
32 or less.
124 SPARES CLEARED
Informational
A set of volumes has been
migrated from one array controller
to a different array controller that
already has configured volumes
on it. The migrated volumes have
spares defined for them that conflict
with the existing configuration. The
defined spares have been deleted
so as to allow the migration to
proceed.
Run the Storage Management
Utility (SMU) or MSA Command
Line Interface (MSA-CLI) to reassign
spare hard drives as needed.
125 ACCESS CONTROL
CONFLICT DETECTED
Error
A set of volumes have been
migrated from one array controller
t
o a different array controller that
a
lready has configured volumes
o
nit.Themigratedvolumeshave
access controls defined for them
that conflicts with the existing
configuration. The access controls
have been modified so as to allow
the migration to proceed.
Run the HP Storage Management
Utility or MSA-CLI to check the new
access controls and modify them
if needed.
126 ACCESS CONTROL
RESOURCES EXCEEDED
Error
A set of volumes have been
migrated from one array controller
to a different array controllers that
already has configured volumes
on it. The migrated volumes have
access controls defined for them
that conflicts with the existing
configuration. The access controls
have been modified so as to allow
the migration to proceed.
Run the HP Storage Management
Utility or MSA-CLI to check the new
access controls and modify them
if needed.
12 0
MSA controller LCD panel message descriptions