HP StorageWorks 1510i Modular Smart Array installation and user guide (383070-002, July 2008)

3. To add a new iSCSI target that your ESX Server host can use for a SendTargets session, click Add.
The Add Send Targets Server dialog box displays.
4. Enter the Send Targets server IP address, and click OK.
5. To change or delete a Send Targets server, select the server and click Edit or Remove.
Setting up CHAP parameters for software initiators
When configuringyouriSCSIsoftwareinitiator,makesurethatCHAPparametersareenabledfor
the initiator. If they are not enabled, set them up.
NOTE:
For more information, see “iSCSI security” on page 70.
1. Open the iSCSI Initiator Properties dialog box.
2. Click the CHAP Authentication tab.
The tab displays the default CHAP parameters.
72
Configuration