HP StorageWorks 1510i Modular Smart Array installation and user guide (383070-002, July 2008)

10. In the Send File window:

a. Click Browse, navigate to the directory in which you placed the ﬁrmware ﬁles, and then select

the ﬁrmware ﬁle.

b. Expand the Protocol drop-down box, and then select 1K Xmodem.

c. Click Send. A 1K Xmodem status window is displayed.

11 . Wait for a completion message to display.

For example, the following messages are displayed on the MSA controller LCD panel:

MSA1510i update: 307 FIRMWARE FLASH DONE

MSA20 upda

te: 313 FIRMWARE FLASH DONE ON BOX <n> (Each attached storage enclosure

is updated one at a time, in sequential box number order.)

NOTE:

Do not interfere with or cancel the download process. Interrupting the download process

might corrupt the ﬁrmware.

12. Restart the MSA and its attached storage enclosures storage system by doing the following (newly

downloaded ﬁrmware is not activated until the MSA is restarted):

IMPORTANT:

When powering down the MSA storage system, you must do so in the following sequence.

If the MSA chassis is powered on before the hard drive storage enclosures complete their

startup routines, conﬁguration settings and data stored on the enclosures will not be visible.

a. Press and hold down the MSA Power On/Standby button for approximately ﬁve seconds to

place the MSA in Standby mode.

b. Power off all storage enclosures attached to the MSA.

c. Wait approximately two minutes to ensure that the hard disk drives in the enclosures stop

rotating.

d. Restart all storage enclosures attached to the MSA.

e. Wait approximately four minutes to allow the enclosures to complete their startup routines.

f. Press and release the MSA Power On/Standby button to restart the MSA.

g. Wait (up to eight minutes) for the STARTUP COMPLETE message to display on the MSA

controller LCD panel.

1510i Modular Smart Array installation and user guide