HP StorageWorks 1510i Modular Smart Array installation and user guide (383070-002, July 2008)

3. Using the emulator transfer (or send file) command, send the firmware to the controller.
The following instructions and examples use HyperTerminal. For more information, see user
documentation for your emulator program.
a. On the menu bar at the top of the HyperTerminal window, select Transfer > Send File.
b. Click Browse and navigate to the location of the firmware image obtained in step 1.
c. Expand the Protocol drop-down box and select 1K XModem.
d. Click Send.
A status window is displayed.
4. Wait f
or the transfer process to complete.
NOTE:
This p
rocessmaytakeupto15minutes.Donotinterruptthisprocess.
5. Wait for the controller to automatically restart.
6. In dual-controller configurations only, if the newly installed firmware on the recovered controller
differs from the firmware on the active controller, the CLONE FIRMWARE LCD message is displayed.
See Cloning controller firmware.
92
Operation and management