HP StorageWorks 1510i Modular Smart Array firmware 2.
Version: 2.0 Description MSA1510i Active/Active controller firmware version 2.0 Update recommendation Recommended for all MSA1510i configurations, both single-controller and dual-controller. Supersedes All previous firmware versions. Product models HP StorageWorks 1510i Modular Smart Array (MSA1510i) Devices supported For a list of supported servers, hard drive storage enclosures, and other network components, navigate to the MSA1510i QuickSpecs on the MSA family website: http://www.hp.com/go/msa.
• • • • • • show portal_group • show iscsi_keys • show initiator Added the following CLI command enhancements, adding the following new commands for Active/Active: • show preferred_path; set preferred_path • show auto_path_change; set auto_path_change • show proxystats • show taskstats Added the following ADU enhancements: • Added Discovey, iSNS and iSNS server settings to ADU report. • Added MIB statistics to ADU report. • Converted index numbers in ADU report into readable form.
Important notes and service considerations To install the firmware, use the procedures and instructions provided in these instructions and on the MSA1510i Support CD, version 2.0. An ISO image of the CD is available on the MSA1510i support page: http://www.hp.com/support. Please note the following: • MSA1510i firmware 2.0 is backward compatible with all previous firmware versions. • MSA1510i firmware version 2.
2. Update the firmware using the HP Storage Management Utility (SMU): a. Point your browser to and open the SMU. b. Select the Configure tab. c. Select Controller (Active) > Flash Firmware. d. Click Browse, navigate to the location of the previously downloaded MSA20 firmware image file, and then select OK. Progress is indicated in the browser with "Flashing Firmware ........" e. Wait for the following popup message The operation completed successfully.
4. In the SMU, select Storage System > Reset System to restart the MSA1510i. IMPORTANT: In dual controller configurations, the second controller MUST be updated to the same image to complete the update cycle. When the system is restarted, the new firmware will automatically be cloned from the just-updated controller over to the other controller. For more information, see the "Redundant-controller firmware cloning" instructions in the HP StorageWorks 1510i Modular Smart Array maintenance and service guide.
