HP StorageWorks 1510i Modular Smart Array firmware 2.
Version: 2.02 Description MSA1510i Active/Active controller firmware version 2.02 Update recommendation and dual-controller. Supersedes Recommended for all MSA1510i configurations, both single-controller All previous firmware versions. Product models HP StorageWorks 1510i Modular Smart Array (MSA1510i) Devices supported For a list of supported servers, hard drive storage enclosures, and other network components, navigate to the MSA1510i QuickSpecs on the MSA family website: http://www.hp.com/go/msa.
• Added the following CLI command enhancements, limiting output display for the following commands: • show ip • show arp • show discovery • show isn_server • show acl_entry • show target • show portal • show portal_group • show iscsi_keys • show initiator • Added the following CLI command enhancements, adding the following new commands for Active/Active: • show preferred_path; set preferred_path • show auto_path_change; set auto_path_change • show proxystats • show taskstats • Added the following ADU enhanc
• Fixed popup message when changing hostname or non-ip fields on management setting screen to warn of session loss. • Fixed incorrect display of Logical LUNs after forcwfirstwrite. • Fixed controller reboot if portal added/deleted from other controller. Prerequisites MSA1510i firmware 2.02 requires the following components on the server: • Windows: Microsoft iSCSI Initiator 2.08, MPIO software, and Microsoft Device Specific Module (DSM) IMPORTANT: Before installing and using 2.
• After updating MSA20 firmware, the controller shelf and ALL MSA20 and MSA30 attached storage enclosures must be power-cycled. • Any attached MSA20 storage enclosures must be at firmware version 2.08 prior to installing MSA1510i firmware version 2.02. Installation instructions If your MSA1510i setup includes one or more attached MSA20 storage enclosures, you must update the firmware on all MSA20s before updating the MSA1510i. Use the following instructions to update MSA20 firmware: 1.
3. Update the firmware using the HP Storage Management Utility (SMU) : a. Point your browser to and open the SMU. b. Select the Configure tab. c. Select Controller (Active) > Flash Firmware. d. Click Browse, navigate to the location of the previously downloaded MSA1510i firmware image file, and then select OK. Progress is indicated in the browser with "Flashing Firmware ........" e. 4. Wait for the following popup message The operation completed successfully.