HP StorageWorks Simple SAN Connection Manager user guide (5697-0083, August 2009)
HP StorageWorks Simple SAN Connection Manager user guide 115
9 Managing storage subsystems
This chapter covers the following procedures for managing your storage subsystems (storage arrays):
• “Viewing subsystem information,” page 115
• “Managing storage subsystems,” page 116
• “Refreshing the storage subsystem list,” page 119
• “Updating storage subsystem firmware,” page 120
• “Creating an alias for a storage subsystem,” page 121
• “Configuring a storage subsystem,” page 121
Viewing subsystem information
Simple SAN Connection Manager provides easy access to information about each subsystem within your
SAN.
To view information about a subsystem:
1. In the navigation pane under Storage subsystem-Logical Disk View, click the subsystem you want to
view.
The content pane (Figure 84) shows the Subsystem Information.
Figure 84 Subsystem Information
The following read-only information is shown for the selected subsystem:
•Subsystem Information:
•Identifier
•Status