HP StoreEver MSL6480 Tape Library User and Service Guide Addendum (QU625-96016, October 2013)

Viewing library or partition configuration settings
In the Status > Partition Map > Configuration Status screen you can see the current configuration
settings for a partition. Expand the sections for additional information.
NOTE: The configurations listed in this screen can be modified using the Expert Partition Wizard.
• Partition Number — The partition number assigned by the library
• Partition Name — The partition name assigned with one of the partition wizards
• Partition S/N — The partition serial number assigned by the library
• Number of Drives — The number of tape drives configured for the partition. Expand the section
to see information about each drive, including the drive number, LTO generation, interface,
and serial number.
• Number of Slots — The number of storage slots assigned to the partition
• Number of Mailslots — The number of mailslots assigned to the partition
• Barcode Label Length Rep. to Host — The number of barcode characters reported to the host
application.
• Barcode Label Alignment Rep. to Host — The end of the barcode label reported to the host
application when reporting fewer than the maximum number of characters. For example,
when reporting only six characters of the barcode label 12345678, if alignment is left, the
library will report 123456. If alignment is right, the library will report 345678.
• Key Manager Type — The type of encryption key manager configured for use with the partition.
• Active Control Path Drive — The tape drive that hosts the LUN for the partition
• Passive Control Path Drive — The tape drive that the library will use as an alternate if there
is a failure of the active control path drive.
• CPF Setting — Enabled when basic command path failover is enabled
• DPF Setting — Enabled when basic data path failover is enabled
6 Introduction