HP StoreEver MSL6480 Tape Library User and Service Guide Addendum (QU625-96016, October 2013)

Changing the token PIN
Figure 2 Changing the PIN or token name
1. Navigate to the Configuration > Encryption > USB — MSL Encryption Kit screen.
2. Expand the Pin Management section.
3. Enter the current and new PINs.
The PIN must be at least 8 characters and no longer than 16 characters. The PIN must contain
at least one lower case letter, one upper case letter, and at least two digits.
4. Click Submit.
CAUTION: The key server token protects the encryption keys with a PIN. If you lose the PIN, you
will not be able to restore data from your encrypted tapes using that token. Neither you nor a
service engineer can recover a lost PIN. Keep a copy of the PIN in a safe place.
Changing the token name
1. Navigate to the Configuration > Encryption > USB — MSL Encryption Kit screen.
2. Expand the Pin Management section.
3. Enter the new token name. The name can have up to 126 characters.
TIP: Using a descriptive name, including the dates when the keys on the token were used,
could be helpful if your log of tapes written with keys on the token is lost.
4. Click Submit.
8 Introduction