HP StoreEver MSL2024, MSL4048, MSL8048, and MSL8096 Tape Libraries User and Service Guide (AK378-96059, December 2012)

1. Loosen the two blue thumbscrews on the library controller and remove it from the library, as
shown in Figure 145 (page 213).
Figure 145 Removing the library controller
2. Place the library controller into a static safe bag.
Removing the base chassis
You will need a #2 Phillips screwdriver to remove and replace the base chassis assembly from the
rack or cover.
CAUTION: Lift the library from the side edges. Lifting the library from the magazine or tape drive
openings can damage the library.
To remove the base chassis from the rack or table top conversion cover:
1. Obtain adequate assistance to lift and stabilize the library during removal and replacement.
2. From the front of the library (see Figure 146 (page 213), 1) loosen the screws inside the left
and right front bezel (these are captive screws and cannot be removed), then 2) slide the
library out of the rack or cover using assistance.
Figure 146 Removing the base chassis from the rack
Removing and replacing the base chassis 213