HP StorageWorks MSL2024 Tape Library firmware release notes: Firmware version 5.00 (AK378-96035, September 2010)

ManualsBrandsHP ManualsStorageHP StorageWorks MSL4048 2 Ultrium 960 Fibre Channel Drive Library

HP StorageWorks MSL2024 Tape

Library firmware release notes

Firmware version 5.00

Part Number: AK378-96035

First edition: September 20, 2010

Summary of content (6 pages)

PAGE 1
HP StorageWorks MSL2024 Tape Library firmware release notes Firmware version 5.
PAGE 3
Version: 5.00 Description This release includes updated firmware for the HP StorageWorks MSL2024 Tape Library. The firmware can be updated through any of the following methods: • Remote management interface (RMI). • Operator control panel (OCP) using a USB flash drive. • HP Library and Tape Tools (L&TT). Library firmware version 5.00 Compatible robotics firmware version Update recommendation Supersedes 3.00e Recommended All previous versions of Library firmware.
PAGE 4
• The cleaning tape barcode label is now recorded into the cartridge memory for LTO-4 and LTO5 drives. • Fixed a case where the drive status displayed as READY on the OCP and RMI while the drive was not connected. The drive status now displays OFFLINE when the drive status is not ready. • Fixed a case where, during initialization, a Library with two LTO-5 drives falsely reported that Drive 2 was an LTO-4 drive and needed a firmware update to support encryption.
PAGE 5
4. Click Firmware on the main toolbar. 5. On the Update Firmware tab, select the box next to each device for which you want to update firmware. If firmware is currently available for that device, it is shown in Firmware File in the File Selection section of the screen. 6. Click Start Update at the bottom of the screen to begin the update. Determining current version To find the version of firmware installed on the Library from the RMI, see the Support: Firmware screen.
PAGE 6
Firmware version Released Status 4.90 3/22/2010 Active 5.