MSL Series Power Supply Replacement

Using a Phillips screwdriver, remove the mounting

screw(s) securing the power supply locking bracket.

Push down on the latch and then use the handle

to pull the power supply out of the receiver.

Push the power supply into the receiver until the

latch engages.

Using a Phillips screwdriver, secure the power

supply locking bracket using the mounting screw(s).

Connect each power cord and turn on the

master power switch for each power supply.

If necessary, turn the library on by touching the

GUI control panel.

Note: Ensure that the replacement

power supply power switch is in the

off position.

Position the power supply at

the back of the library with

the latch at the top,

and the power switch

at the bottom.

replacement

10U