HP StorageWorks U320e SCSI Host Bus Adapter user guide (AH627-96001, March 2007)

Installing the adapter hardware
CAUTION:
Electrostatic d
ischarge can damage electronic components. Be sure you are properly grounded bef ore
beginning this
procedure. For more information, see "Appendix: Electrostatic discharge"onpage53.
To install the host bus adapter hardware:
1. Open the ser ver case.
WARNING!
Toreducetheriskofpersonalinjuryfromhotsurfaces,allowthedrivesandtheinternal
system components to cool before touching them.
2. Install the adapter in the selected PCIe expansion slot. Consult your computer's documentation if you
have questions about how to install an expansion card in your system.
3. Close the computer case.
Connecting the devices
To connect the devices:
1. Connect SCS
I devices with SCSI cables.
Insert a SCSI cable into a connector on the HP U320e SCSI Host Bus Adapter, as shown in Figure 5.
Verify that the connector is properly seated and tighten the screws on the connector. Connect the
other end of the cable to the firstdeviceinthebus.Connecttherestofthedevicestoeachother,if
applicable. Repeat to connect the devices to the second bus, if applicable.
11318
2 3
1
Figure 5
Connecting the SCSI cable and terminator
1. SCSI cable connection on the adapter
2. SCSI cable connection on the device
3. SCSI terminator
2. Connect a terminator to each device at the end of a SCSI bus.
3. Reconnect the po wer cables.
User guide
17