Brocade Fabric OS Message Reference - Supporting Fabric OS v5.3.0 (53-1000437-01, June 2007)

Fabric OS Message Reference 271
53-1000437-01
Chapter
38
IPS System Messages
IPS-1001
Message <timestamp>, [IPS-1001], <sequence-number>,, WARNING, <system-name>, <message>
FCIP License Not Installed (<error>)
Probable Cause Indicates that the FCIP license is not installed on the switch.
Recommended
Action
Run the licenseShow command to check the installed licenses on the switch. Contact your switch
supplier for a FCIP license. Run the licenseAdd command to add the license to your switch.
Severity WARNING
IPS-1002
Message <timestamp>, [IPS-1002], <sequence-number>,, ERROR, <system-name>, Failed to
initialize <module> rc = <error>
Probable Cause Indicates that an initialization of a module within the IPS daemon failed.
Recommended
Action
Download a new firmware version using the firmwareDownload command. Refer to the Fabric OS
Command Reference for more information on this command.
Severity ERROR
IPS-1003
Message <timestamp>, [IPS-1003], <sequence-number>,, WARNING, <system-name>, <function
name>(): Failed to allocate memory while performing <message>
Probable Cause Indicates that memory resources are low. This might be a transient problem.
Recommended
Action
If the message persists, check the memory usage on the switch, using the memShow command.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity WARNING
IPS-1004
Message <timestamp>, [IPS-1004], <sequence-number>,, WARNING, <system-name>, Port Config
Mode Mismatch slot (<slot>) port(ge<port>): current mode is (<current mode>)