Brocade Fabric OS Message Reference - Supporting Fabric OS v5.3.0 (53-1000437-01, June 2007)

Fabric OS Message Reference 303
53-1000437-01
Chapter
51
PDM System Messages
PDM-1001
Message <timestamp>, [PDM-1001], <sequence-number>,, WARNING, <system-name>, Failed to
parse the pdm config.
Probable Cause Indicates that the parity data manager (PDM) process could not parse the configuration file. This
might be caused by a missing configuration file during the installation.
Recommended
Action
Run the firmwareDownload command to reinstall the firmware.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity WARNING
PDM-1002
Message <timestamp>, [PDM-1002], <sequence-number>,, WARNING, <system-name>, ipcInit
failed.
Probable Cause Indicates that the parity data manager (PDM) process could not initialize the inter-process
communication (IPC) mechanism.
Recommended
Action
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity WARNING
PDM-1003
Message <timestamp>, [PDM-1003], <sequence-number>,, WARNING, <system-name>, pdm [-d] -S
<service> -s <instance>.
Probable Cause Indicates that a syntax error occurred when trying to launch the parity data manager (PDM)
process.
Recommended
Action
Run the firmwareDownload command to reinstall the firmware.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity WARNING